Stache No Weld Banger

The Stache No Weld Banger is a full quartz piece with no welds, which sets it apart from standard bangers that are assembled from two separate pieces of quartz joined by a weld. The no-weld construction means the entire banger, from the joint to the bucket, is one continuous piece of quartz. This makes the banger stronger, more durable, and less prone to joint separation compared to welded banger designs.

The Stache No Weld Banger is compatible with any 14mm female joint rig. The 14mm joint is the most widely used size in the dab rig and water pipe industry, making this banger easy to pair with most standard rigs. Before purchasing, confirm your rig has a 14mm female joint to ensure a proper fit and secure seal during use.

The Stache No Weld Banger is 3mm thick. This thickness provides good heat retention, allowing the quartz banger to hold temperature after the torch is removed for a consistent dabbing experience. The 3mm build also supports both cold start and hot start dabbing methods, giving users flexibility in how they prefer to take their concentrate sessions.

Yes, the Stache No Weld Banger supports both cold starts and hot starts. For a cold start dab, load your concentrate directly into the unheated banger, cap it with a carb cap, then apply torch heat gradually from below until the concentrate starts to vaporize. The 3mm quartz and no-weld construction heat evenly, making cold start dabbing straightforward with this banger.

The Stache No Weld Banger is compatible with any 14mm female joint rig, but Stache notes that when used on the Rig In One, it may not always align perfectly with the integrated torch. For standalone dab rigs and water pipes with a standard 14mm female joint, this quartz banger will fit and perform as intended without alignment concerns.

To clean the Stache No Weld Banger, allow it to cool completely after each session, then use a cotton swab soaked in isopropyl alcohol to wipe out any residual concentrate from the bucket. Because this banger is a no-weld, single-piece construction, there are no weld seams or rough areas where residue can accumulate, making cleanup straightforward. For deeper cleaning, soak in isopropyl alcohol, rinse with warm water, and dry fully before the next session.