Pulsar Terp Slurp Banger

A terp slurper banger uses a built-in lower stem and dish at the base of the bucket. You load concentrate directly onto the heated dish at the bottom instead of dropping it into the top of the bucket. As you inhale, airflow enters through angled slits at the base of the inner tube, creating a vortex that pulls melted concentrate upward through the tube and spreads it across the heated quartz surface for efficient vaporization. This design reduces wasted oil and is especially effective for low temperature dabbing.

This banger works best with a marble-style carb cap that rests on the open top of the bucket. The rounded marble cap creates airflow restriction over the top of the banger while allowing you to tilt and rotate the cap to direct airflow downward. This rotational action helps spin any terp beads you have added inside the banger. Standard flat disc caps can also be used but may not generate the same level of spinning airflow as a marble or directional carb cap.

Terp beads are not required but are highly recommended with a terp slurper banger. When dropped into the bottom chamber of the banger, terp beads spin in response to the incoming airflow vortex, stirring melted concentrate and spreading it across the heated quartz surface. This action reduces pooling of oil and promotes more complete vaporization. Using terp beads with this banger generally results in better flavor and less residual concentrate left behind after your dab.

Heat should be applied to the bottom dish of the terp slurper, which is the flat tray at the very base of the lower stem. Torch the dish until it reaches your desired temperature. Avoid applying direct flame to the central column or bucket area where terp beads are seated, as rapid heating of that zone can cause thermal shock and crack the quartz. Allow the banger to cool for 30 to 60 seconds after removing the flame before loading concentrate onto the dish.

The Pulsar Terp Slurp Banger has a 14mm male joint at a 90 degree angle. This means it is designed for dab rigs and water pipes that have a 14mm female joint with a 90 degree opening. The 90 degree configuration is the most widely used angle in the industry and fits the majority of standard inline dab rigs, recyclers, and banger hanger water pipes available on the market.

After each use, use a cotton swab dampened with isopropyl alcohol to wipe out the bottom dish and the inside of the central tube while the banger is still warm but not hot. The slitted design of the dish can accumulate residue in the slits over time, so periodic soaking in high-concentration isopropyl alcohol for 20 to 30 minutes helps dissolve any built-up oil. Rinse thoroughly with warm water and allow the banger to dry completely before the next session. Never dunk a hot banger into liquid.