GRAV Slurper Bucket Quartz Banger Set – 3pc – 14mm M

The GRAV Slurper Bucket uses a dual-cylinder structure with a thick gathered dish base engineered for larger low-temperature dabs. Laser-cut directional air intakes create a more controlled whirling airflow compared to the simple slits on basic terp slurpers, resulting in more consistent concentrate movement and vapor production. The included terp pillar insert also provides additional surface area inside the column for the spinning motion to act on.

The terp pillar is a cylindrical quartz insert that sits inside the column of the slurper bucket. During inhalation, the spinning airflow created by the laser-cut slits rotates the pillar, which acts as a surface that concentrates coat and vaporize on as they are drawn upward. The pillar increases the total heated surface area and contributes to more thorough vaporization with less waste per session.

GRAV offers this slurper bucket in both 45-degree and 90-degree joint angles. The 45-degree version is suited for dab rigs with an angled or bent-neck downstem, while the 90-degree version fits rigs with a straight vertical joint. Check your rig geometry before selecting to ensure the banger sits level when inserted.

The extended joint places more distance between the heated bucket and the body of the dab rig, protecting the rig joint from repeated direct heat exposure that can weaken borosilicate glass connections over time. It also allows the bucket area to hold higher temperatures without transferring as much heat to the water in the rig body below.

Use a dab tool to place concentrate directly into the outer lower dish after the banger has been heated and allowed to cool slightly. Once the marble cap is placed on top and you begin to inhale, the directional air slits draw the melted concentrate upward through the column for complete vaporization. Bottom-loading reduces dripping and concentrate loss compared to top-loading bucket bangers.

After each use, clean the dish and column with an isopropyl alcohol-soaked cotton swab while the piece is still slightly warm. Remove the terp pillar and clean it separately. For a deeper clean, soak the banger, marble, and pillar in isopropyl alcohol for 20 to 30 minutes, rinse with warm water, and allow all pieces to dry completely before reassembly.