Bear Quartz V1 Slurper Banger Set – 4pc – 90 Degree

A terp slurper has a lower stem and dish below the main bucket. When concentrate is loaded into the bottom dish and the top is capped with a marble, inhaling pulls air through angled slits at the base of the stem. This creates an upward vortex that draws melted oil up the walls of the banger for more complete vaporization compared to a standard flat-bottom bucket.

The set includes the Bear Quartz V1 Slurper banger, a 22mm marble carb cap, a 12mm terp marble insert that seats inside the banger to prevent oil from entering the stem, and a 6mm terp pearl that spins within the banger to stir concentrate for even vaporization.

The V1 Slurper Banger Set is offered in both 10mm and 14mm male joint sizes, both at a 90-degree angle. The 10mm option is ideal for mini rigs, while 14mm suits standard-sized dab rigs and water pipes.

Place the 6mm terp pearl inside the banger, then seat the 12mm marble in the middle column. Heat the bottom dish and lower stem evenly with a torch and allow it to cool to your preferred temperature. Load concentrate directly onto the bottom dish, place the marble carb cap on top, and inhale slowly to activate the slurper vortex.

The full weld seamless construction joins the bucket and neck from a single continuous piece of quartz, eliminating the traditional weak point where the two sections meet. This is especially important on terp slurpers, where precise airflow through the slits requires consistent quartz geometry that a standard weld can compromise over time.

After each session, use a thin cotton swab to clean the inside of the lower stem and dish while the banger is still warm. For the marble inserts and carb cap, soak them in isopropyl alcohol for 15 to 30 minutes, then rinse with warm water. Avoid harsh abrasives that can scratch the quartz surface.