Pulsar Standard Quartz Banger – 90 Degree – 14mm M

The Pulsar Standard Quartz Banger has a 22mm outer diameter bucket. This is slightly smaller than the 25mm standard found on many larger flat top bangers. When selecting a carb cap for this banger, choose one designed for a 22mm opening or a bubble cap that can create a partial seal over the top. Terp pearls used with this banger should be small enough to spin freely inside the 17mm inner diameter without jamming against the walls.

Yes, the Pulsar Standard Quartz Banger is designed as a reliable everyday replacement nail. It is made from pure quartz for clean, flavor-neutral vapor and includes the Pulsar logo etched on the barrel. The flat top design is compatible with a wide range of carb caps, and the 90 degree 14mm male joint fits most standard dab rigs. For users who want a clean, functional quartz banger without additional accessories or specialty features, this is a practical and straightforward option.

The flat top edge of this banger works with bubble carb caps, directional flow carb caps, and flat disc-style caps. Any carb cap with a diameter at or slightly wider than 22mm can create a working seal over the opening. Bubble caps that are wider than the bucket opening sit on top and create a loosely fitting seal that you can adjust by tilting and rotating the cap to control airflow direction. Directional flow caps with a narrow tube pointing down through the opening also work well with flat top bangers.

The Pulsar Standard Quartz Banger has a 2mm wall thickness. Thinner quartz walls heat up faster but also cool down more quickly than bangers with 3mm or 4mm walls. This makes the standard banger well suited for users who prefer to dab at moderate temperatures and who torch and dab within a relatively short heating cycle. The 2mm wall construction keeps the banger lightweight and is typical of entry-level and mid-range standard flat top quartz nails.

This banger uses a 14mm male joint at a 90 degree angle. It is designed for rigs and water pipes with a 14mm female joint at a 90 degree angle. The 14mm 90 degree configuration is the most common joint type found on mid-size dab rigs, banger hangers, and inline rigs. Before purchasing, verify the joint size and angle of your rig to ensure the banger fits securely with an airtight seal.

After each dab, allow the banger to cool slightly and then use a cotton swab to wipe residual oil from the inside of the bucket while it is still warm. This prevents concentrate from burning onto the quartz and turning it dark. For deeper cleaning, soak the banger in 91 percent or higher isopropyl alcohol for 20 minutes, then rinse thoroughly with warm water and allow to dry before the next session. The 2mm walls clean easily and the flat bottom of the bucket is straightforward to swab without hard-to-reach corners.